![\"\"](\"https:\/\/orbitalhub.com\/wp-content\/uploads\/2008\/09\/ATV-3D-view.jpg\" "\\"The")
<\/a>\nCredits: ESA<\/small><\/div>\n
\u00a0<\/p>\n
In September 2008, the first Automated Transport Vehicle (ATV) mission will come to an end. It is a significant achievement for the European space industry, marking another first in space exploration: the ATV spacecraft is capable of performing rendezvous and docking procedures to the International Space Station (ISS) in a fully autonomous manner. In comparison, the Russian spacecrafts used for carrying supplies and crews to the station (Progress and Soyuz) need the cooperation of the station for docking procedures.<\/p>\n
\u00a0<\/p>\n
The ATV program started back in 1995 and it has so far cost approximately 1.3 billion euros.<\/p>\n
\u00a0<\/p>\n<\/div>\n
\u00a0<\/p>\n
I will start by presenting some of the technical data of the ATV spacecraft. It will not be an exhaustive presentation by far, but I think it is important to have the orders of magnitude at least.<\/p>\n
\u00a0<\/p>\n<\/div>\n
<\/a>\nCredits: ESA<\/small><\/div>\n
\u00a0<\/p>\n
ATV has a mass of almost 21 tonnes (20,750 kg) at launch, of which up to 7 tonnes is on-board propellants and payload. The pressurized cabin section used for cargo storage has 48 cubic meters in volume. ATV is the largest spacecraft ever developed in Europe.<\/p>\n
\u00a0<\/p>\n
In the on orbit configuration, the spacecraft has a length of 9.794 m, maximum diameter of 4.480m, and the solar arrays span of 22.281 m.<\/p>\n
\u00a0<\/p>\n
The launch vehicle used by ATV missions is Ariane 5. The ATV is deployed by the Ariane 5 rocket on a low Earth orbit (260×260 km, inclination 51.6 degrees).<\/p>\n
\u00a0<\/p>\n<\/div>\n
<\/a>\nCredits: ESA<\/small><\/div>\n
\u00a0<\/p>\n
The ATV spacecraft consists of two main modules, the avionics\/propulsion module, called the ATV Service Module, and the Integrated Cargo Carrier (ICC), which docks with the International Space Station (ISS).<\/p>\n
\u00a0<\/p>\n<\/div>\n
<\/a>\nCredits: ESA<\/small><\/div>\n
\u00a0<\/p>\n
The ICC represents 60% of the total ATV volume. It is used to deliver two types of supplies to the ISS: the dry cargo (like hardware and personal parcels) and the fluid cargo (like propellant for the ISS\u2019s own propulsion system, water, and gas).<\/p>\n
\u00a0<\/p>\n
Cargo mass can be distributed as follows:
\n\u00b7 dry cargo: 1,500 kg \u2013 5,500 kg;
\n\u00b7 water: 0 \u2013 840 kg;
\n\u00b7 gas (nitrogen, oxygen, air, 2 gases\/flight): 0 \u2013 100 kg;
\n\u00b7 ISS re-boost and attitude control propellant: 0 \u2013 4,700 kg;
\nThe total cargo upload capacity: 7,667 kg.<\/p>\n
\u00a0<\/p>\n<\/div>\n
<\/a>\nCredits: ESA<\/small><\/div>\n
The waste download capacity is 6,340 kg (5,500 kg dry cargo + 840 kg wet cargo).<\/p>\n
\u00a0<\/p>\n
The front of the ICC contains the docking system. The docking system is Russian made and it is a state-of-the-art docking mechanism. It has evolved over the years from the original docking system used for the Salyut space station program in the late 1960s. The docking system enables crew access to the ICC pressurized module, but also provides electrical and propellant connections between the ATV and the ISS.<\/p>\n
\u00a0<\/p>\n<\/div>\n
\u00a0<\/p>\n
In order to make docking a safe procedure, the ICC is equipped with quite an impressive array of sensors and active components: two telegoniometers (used to calculate the distance and direction from ATV to ISS), two videometers (used to compute distance and orientation of the ISS), two star trackers, and two visual video targets (used by the ISS crew to monitor visually the ATV\u2019s final approach).<\/p>\n
\u00a0<\/p>\n<\/div>\n
<\/a>\nCredits: ESA<\/small><\/div>\n
The ATV Service Module includes the propulsion systems, the electrical power, computers, the communications, and the avionics.<\/p>\n
\u00a0<\/p>\n
The main propulsion system of the spacecraft is comprised of 4 x 490 N thrusters. The attitude control system relies on 28 x 220 N thrusters. The ATV propulsion system is a pressure fed liquid bi-propellant system using monomethyl hydrazine fuel and nitrogen tetroxide oxidizer. The fuel is pressurized by helium stored in two high pressure tanks.<\/p>\n
\u00a0<\/p>\n
The four solar panels ATV is equipped with can generate 4,800 W on average during the 6 month mission in space.<\/p>\n
\u00a0<\/p>\n
The typical ATV mission starts in French Guiana, at the Kourou launch site. An Ariane 5 rocket deploys the ATV spacecraft on a circular Low Earth Orbit (LEO) at an altitude of 260 km. ATV then activates its navigation systems and fires its thrusters to reach the transfer orbit to the ISS.<\/p>\n
\u00a0<\/p>\n<\/div>\n
\u00a0<\/p>\n
After two or three days, and raising its orbit to 400 km, ATV will be in sight of ISS. It will start the approaching phase of the mission from about 30 km behind and 5 km below the station.<\/p>\n
\u00a0<\/p>\n
Even if the approach and the docking procedures are fully automatic, the flight controllers can at any time call on the spacecraft and back away from the station. The ISS crew can also reject the spacecraft in case any anomalies are noticed.<\/p>\n
\u00a0<\/p>\n<\/div>\n
Once the spacecraft is safely docked to the ISS, the station’s crew can access the pressurized cargo section and remove the payload. After the payload is removed, the crew fills the cargo section with used hardware and waste materials.<\/p>\n
At intervals of 10 to 14 days, the main thrusters of the ATV will be used to boost the station\u2019s altitude.<\/p>\n
Once the mission is accomplished, the ATV separates from the ISS, and performs a controlled and safe destructive re-entry somewhere above the Pacific Ocean.<\/p>\n
\u00a0<\/p>\n<\/div>\n
The first ATV mission is called Jules Verne, after the French author Jules Gabriel Verne (1828 \u2013 1905) who pioneered the science-fiction genre.<\/p>\n
The Jules Verne ATV had to pass many tests in order to qualify for the mission. An interesting test was the acoustic testing<\/a> at the ESA\u2019s test facilities in Noordwijk in the Netherlands.<\/p>\n The spacecraft has to withstand the vibrations caused by the extreme noise levels generated during the launch by the Ariane 5 rocket. The ATV was locked in a closed space with huge speakers that simulate the noise levels recorded during an Ariane 5 launch.<\/p>\n \u00a0<\/p>\n<\/div>\n Even though the ATV is able to perform the rendezvous and the docking procedures on its own, the ground control experts from ESA and CNES, the French space agency, were involved in the operations. They determined the route the spacecraft must follow in order to dock with the ISS. The two ISS control centers were also involved in ATV operations: the Mission Control Centre in Moscow and the Mission Control Center in Houston, Texas.<\/p>\n \u00a0<\/p>\n<\/div>\n \u00a0<\/p>\n The Jules Verne mission is the first in a series to come. There are already five ATV missions scheduled between now and 2015. Under the coordination of ESA and the prime contractor EADS Astrium, European engineers have contributed to this new generation spacecraft. Major sub-contractors are Thales Alenia Space (Italy), Astrium (Germany and France), Oerlikon Space (Switzerland), Dutch Space (The Netherlands), with Russian partners providing the advanced docking system.<\/p>\n \u00a0<\/p>\n<\/div>\n \u00a0<\/p>\n The Jules Verne mission liftoff occurred on March 9th, 2008 at 05:03 CET (04:03 UT) at the Kourou Spaceport in French Guiana.<\/p>\n \u00a0<\/p>\n<\/div>\n ATV Jules Verne had to perform what the media called orbital rehearsals for ISS docking. The initial test, performed on March 14th, demonstrated the Collision Avoidance Manoeuvre (CAM). During this initial test, an automated system took control of the spacecraft and moved it to a safe distance from the ISS.<\/p>\n \u00a0<\/p>\n<\/div>\n<\/a>
\nCredits: ESA<\/small><\/div>\n